Home Repiping Installation Service In South Florida

A single leak is a repair. A pattern of problems means the whole system is failing. Consider a repipe if you’re seeing:

• Repeated pinhole leaks: Fix one and another shows up somewhere else.
• More than one slab leak: A strong signal the under-slab pipes are corroding throughout.
• Rusty, brown, or discolored water: Especially first thing in the morning.
• Low or dropping water pressure: Across multiple fixtures.
• Polybutylene (“poly”) pipes: Gray plastic piping installed in many FL homes from the late 1970s to mid-1990s. It fails without warning, and many Florida insurers now refuse to renew or write policies on homes that still have it.
• Aging cast iron drain/sewer lines: Homes built before the mid-1970s often have cast iron under the slab that’s now corroding, scaling shut, or backing up no matter how often it’s snaked.
• Your home is 25+ years old: With original piping.
• Banging or rattling pipes: Also known as water hammer, along with water that takes forever to heat up.

Our water is hard and chemically aggressive, which corrodes copper from the inside out and produces those frustrating pinhole leaks. Combine that with the polybutylene that was widely installed during the region’s building booms and the simple age of the housing stock, and you have a region where repiping is common—and where neighbors often compare notes because so many homes on the same street need it.

We’ll recommend the right material for your home and budget:

PEX

What it is: Flexible modern plastic tubing
Best for: Most repipes; fewer connections, faster installs
Resists FL corrosion?: Yes — immune to the pinhole corrosion that plagues copper
Cost: Lower
Install disruption: Less (flexible, fewer fittings)

Copper

What it is: Traditional rigid metal pipe
Best for: Homeowners who prefer metal; certain exposed runs
Resists FL corrosion?: Vulnerable to aggressive-water corrosion over time
Cost: Higher
Install disruption: More

For many Broward and Palm Beach homes, a hybrid heat-pump water heater is quietly the smartest pick—our warm climate is exactly the condition that makes them so efficient. We’ll tell you straight which option pays off for your home.

• In-home walkthrough and free written proposal: We map every line and fixture.
• We protect your home: Floors, furniture, and belongings are covered before we start.
• Strategic wall/ceiling access: Small, planned openings (not demolition).
• New lines run: Routed to every fixture, then connected and pressure-tested.
• City inspection: Repipes are permitted; we handle the permit and inspection.
• Patch and restore: We close and finish the access points.

Most whole-home repipes take 2–5 days depending on home size and the number of bathrooms. We keep your water on as much as possible and walk you through the schedule up front. Financing is available, and many homeowners roll a repipe into a planned remodel.

Family-run and serving Broward and Palm Beach County since 2012, with upfront pricing, complimentary second opinions, financing, and a 100% satisfaction guarantee. Licenses #CFC1429264 · #EC13003477 · #CAC1823791.